ZFS autobackup

Introduction

ZFS-autobackup tries to be the most reliable and easiest to use tool, while having all the features.

You can either use it as a backup tool, replication tool or snapshot tool.

You can select what to backup by setting a custom ZFS property. This makes it easy to add/remove specific datasets, or just backup your whole pool.

Other settings are just specified on the commandline: Simply setup and test your zfs-autobackup command and fix all the issues you might encounter. When you're done you can just copy/paste your command to a cron or script.

Since it's using ZFS commands, you can see what it's actually doing by specifying --debug. This also helps a lot if you run into some strange problem or errors. You can just copy-paste the command that fails and play around with it on the commandline. (something I missed in other tools)

An important feature that's missing from other tools is a reliable --test option: This allows you to see what zfs-autobackup will do and tune your parameters. It will do everything, except make changes to your system.

Features

• Works across operating systems: Tested with Linux, FreeBSD/FreeNAS and SmartOS.
• Low learning curve: no complex daemons or services, no additional software or networking needed.
• Plays nicely with existing replication systems. (Like Proxmox HA)
• Automatically selects filesystems to backup by looking at a simple ZFS property.
• Creates consistent snapshots. (takes all snapshots at once, atomicly.)
• Multiple backups modes:
  • Backup local data on the same server.
  • "push" local data to a backup-server via SSH.
  • "pull" remote data from a server via SSH and backup it locally.
  • "pull+push": Zero trust between source and target.
• Can be scheduled via simple cronjob or run directly from commandline.
• Also supports complex backup geometries.
• ZFS encryption support: Can decrypt / encrypt or even re-encrypt datasets during transfer.
• Supports sending with compression. (Using pigz, zstd etc)
• IO buffering to speed up transfer.
• Bandwidth rate limiting.
• Multiple backups from and to the same datasets are no problem.
• Resillient to errors.
• Ability to manually 'finish' failed backups to see whats going on.
• Easy to debug and has a test-mode. Actual unix commands are printed.
• Uses progressive thinning for older snapshots.
• Uses zfs-holds on important snapshots to prevent accidental deletion.
• Automatic resuming of failed transfers.
• Easy migration from other zfs backup systems to zfs-autobackup.
• Gracefully handles datasets that no longer exist on source.
• Complete and clean logging.
• All code is regression tested against actual ZFS environments.
• Easy installation:
  • Just install zfs-autobackup via pip.
  • Only needs to be installed on one side.
  • Written in python and uses zfs-commands, no special 3rd party dependency's or compiled libraries needed.
  • No annoying config files or properties.

Getting started

Please look at our wiki to Get started.

Or read the Full manual

Sponsor list

This project was sponsored by:

• JetBrains
• https://rsync.net
• DatuX